How much do you know about the construction process of floor paint?
Construction process of floor paint one: treatment
The ① base is based on the cement powder smooth or grinding ground.
② must be more than 28 days of health, water needs 8% below the
construction of the ground if there is uneven or empty drums need to be
③ with mortar to fill the ground;
The oil of ④ should be cleaned thoroughly.
The dry and clean of the ⑤ should be maintained before construction.
The ⑥ polishes off the loose layer, the delamination and the cement
residue, makes it hard, flat, and increases the adhesion between the floor
coating and the ground.
Floor Paint Construction Process two: bottom coating
① should be kept clean before construction if there is debris adhesion
should be removed in accordance with the correct proportion of the main agent
and Hardener mixed, fully stirred;
② need to adjust the appropriate viscosity of the ground to finish the
material within 4 hours of construction;
③ Bottom Coating curing time is about 8 hours.
④ the water-based floor closed primer, roll coating, scraping or brushing,
so that it fully wetting concrete, and infiltration into the concrete inner
Floor Paint Construction Process three: medium coating
① need to be kept clean before construction if there is debris adhesion
should be removed according to the correct proportion of the main agent and
Hardener mixed, fully stirred;
② will mix the finished resin into quartz sand, and ③ the material evenly
with a trowel knife;
④ mixing finished material should be completed within 30 minutes of
⑤ Construction Handover Office to do the handover treatment;
⑥ in the coating health hardening time of about 8 hours.
⑦ the medium-coated material and the appropriate amount of quartz sand
mixed evenly, with a trowel knife coated into a certain thickness of the
formation of dense layer.
Construction process of floor paint four: Batch soil
① in accordance with the correct proportion of the main agent and hardening
agent mixed, fully stirred;
② use a batch of knives to spread the material evenly;
③ mixing finished material should be completed within 30 minutes of
④ batch of soil health hardening time of about 8 hours;
⑤ depending on the actual needs of the construction number of requirements
to achieve flat without holes, no batch of knives and sand wear printing.
⑥ using surface coating materials with quartz fine powder batch coating,
fill in the gap between the larger particles, to be completely cured, with
dust-free grinding machine ground, vacuuming dust, grinding flat.
Floor Paint Construction Process five: surface coating
① should be kept clean before the construction of the debris adhesion need
to be removed;
② use before the main agent stirring evenly;
③ in accordance with the correct proportion of the main agent and hardening
agent mixed, fully stirred;
④ Use the drum or trowel knife to evenly coating the material to complete
the construction within 30 minutes.
⑤ construction handover should be handled well;
After the completion of ⑥ construction, 24 hours after the venerable, 72
hours before the pressure (to 250C, low temperature opening time should be
moderately prolonged). The above is about floor paint construction process flow,
I hope to be able to all of you to carry out the construction of floor paint
In addition, the small series also need to remind you that the smooth
development of the premise of the construction of floor paint is to buy quality
products, so we can not careless in this regard.